Hey Guys Im new to the forum and had a question. I made my 98 wide glide a trike and would like to add a Ginz chopper sissy bar, I am customizing a set of side plates to fit beneath the struts against the fender. would anyone know the width of the stock sissy bar for that bike? Any help is greatly appreciated!

 

H-D PN 52655-84



Inside to inside is 5.60"
Outside to outside is 6.73"
It's made from .561" square stock.

I have it in hand, so if you need any other measurements it's no biggie.

 

Thanx brother I appreciate it, now I just have to find out where to ge the 4 set screws?

 

The screws to hold the bar to the side plates?

They're 1/4-28 x 3/4 button head screws. Grade 8. H-D PN: 919

 

Just ordered them, Thanx again!