Dyna rear wheel problems
Thread Starter
|
Stage III
Joined: Aug 2019
Posts: 3
Likes: 1
From: Columbia Tennessee
Dyna rear wheel problems
So I just recently did some motor work to my 07 street bob. Bigger jugs, cams , pistons.. the whole 9. Well Im about 3,000 miles In on that and finally broke some spokes on my rear wheel. So I got a mag wheel from my local shop and the man said it was off of a dyna and would work. I get mine off and go to put new wheel on and my axle will not, and I mean will no go in! Tried it all but I can tell where the axle necks up that its too big to go through my hub/bearings...just wondering what is my alternative here? New wheel all together? New bearings? New axle of smaller size? Please help me out. Thanks
Your bike will have a 25mm axle, if the wheel you got is older than 2006 it should suit a 1" axle so it won't work but it should be loose not too tight?!
New bearings is the answer regardless.
New bearings is the answer regardless.
Road Captain
Joined: Nov 2017
Posts: 711
Likes: 143
From: .
Wrong! 07 has 1" axles. You probably got a rear wheel from 08+ with 25 mm axle. You should only get wheels from 06 and 07 if you want a direct fit without mods.
Thread Starter
|
Stage III
Joined: Aug 2019
Posts: 3
Likes: 1
From: Columbia Tennessee
so new bearings will solve my issue?
Cruiser
Joined: May 2018
Posts: 193
Likes: 51
From: Cumming, GA
Your 07 should have 1" axles. If the wheels you snagged are 08+ they will be 25mm, where 1" is 25.4mm, so it wont work. If you got some 2000-2005 wheels, they are a mix match of 3/4" and 1" depending on year and front or rear wheel. Maybe post up a photo of the wheel you have, and someone like multihdrdr will tell you everything you ever wanted to know about it.
Thread
Thread Starter
Forum
Replies
Last Post
VintageBiker
Touring Models
3
Apr 25, 2010 09:53 PM
