99 dyna will not run
Thread Starter
|
Intermediate
Joined: Apr 2017
Posts: 27
Likes: 0
From: altoona,Pa
99 dyna will not run
bike will not run could use some guidance the following was checked fuel to carb good ,,,float bowl is working good,,,choke cleaned and seem ok both jets clean got .....got spark try starting with the choke in and out nothing any help where to check is help full... no spark coil must of gone
Last edited by lonerider1960; Jul 14, 2023 at 09:56 AM.
Supporter
Joined: Jan 2007
Posts: 15,787
Likes: 5,605
From: along the shore of Mishigami
The crank position sensor reads the fly wheel notches (hall effect) and when it reads a particular spot it sends a signal to the ignition system module to energize the coil then fire a spark plug, I don't know if you have the crank position sensor in the nose cone or on the engine case left front.
Seasoned HDF Member
Joined: Dec 2005
Posts: 19,827
Likes: 7,966
From: poway
The crank position sensor reads the fly wheel notches (hall effect) and when it reads a particular spot it sends a signal to the ignition system module to energize the coil then fire a spark plug, I don't know if you have the crank position sensor in the nose cone or on the engine case left front.
HDF Community Team
Joined: Aug 2018
Posts: 3,010
Likes: 1,188
From: New Hampsha
If you have no spark and the coil failed a proper test, sounds like a new coil would be a good place to start... (pun intended!).
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
James Carlson
General Harley Davidson Chat
2
Apr 29, 2021 09:05 AM