Full Fender Conversion 2017 FXDLS
Thread Starter
|
Stage IV
Joined: Jun 2017
Posts: 4
Likes: 0
From: Lemon Grove
Full Fender Conversion 2017 FXDLS
Hi Everyone, I am trying to finish up my conversion and hoping someone has run into the same issue I have. I got an OEM full fender, the Moons MC v4 integrated taillight, the Moons MC circuit board, and the Guerilla wire harness.
I got everything installed and buttoned up, but when I turn the bike on, the brake light stays constantly on and my hazards don't work. The right and left signal appear to work but after unplugging one of them from the circuit board, it looks like they're only half working.
The v4 taillight has a "running" signal where the signal strobes or pulses outward in the direction of the signal, kinda like the later Mustangs with the three tail lights. With one of the signal leads unplugged from the circuit board, the other signal works as it should. Same thing happens if I unplug either side.
Hopefully has come across this and point me in the right direction.
-Steve
I got everything installed and buttoned up, but when I turn the bike on, the brake light stays constantly on and my hazards don't work. The right and left signal appear to work but after unplugging one of them from the circuit board, it looks like they're only half working.
The v4 taillight has a "running" signal where the signal strobes or pulses outward in the direction of the signal, kinda like the later Mustangs with the three tail lights. With one of the signal leads unplugged from the circuit board, the other signal works as it should. Same thing happens if I unplug either side.
Hopefully has come across this and point me in the right direction.
-Steve
Thread
Thread Starter
Forum
Replies
Last Post
jackietan
Ignition/Tuner/ECM/Fuel Injection
1
Jun 18, 2009 12:42 AM
