Couple of questions on the dwg
Thread Starter
|
Cruiser
Joined: Mar 2007
Posts: 248
Likes: 2
From: Shenandoah Valley, VA
Couple of questions on the dwg
I have an `01 wideglide and wish to \\;replace the passenger pegs with \\;floorboards\\; however, looking at the different styles I see a few that allow \\;a 15 degree rotation but I don't believe that to be enough. Anyone have photos they can post or PM me with passanger floorboards mounted. Again, this is an `01 so the peg mounts are wielded to to the frame on the right side.
 \\;
Also, is there a kit to relocate the rear turn signals? Anyone done this? Photo of that would also be great.
 \\;
Thanks
 \\;
Also, is there a kit to relocate the rear turn signals? Anyone done this? Photo of that would also be great.
 \\;
Thanks
Elite HDF Member
Joined: Aug 2007
Posts: 4,265
Likes: 99
From: Northern VA
RE: Couple of questions on the dwg
Probably not a lot of help, but I installed HD's floor boards cuz I couldn't find any aftermarket products that I liked. \\; They were expensive, but good quality. \\; And wifey loves em...
 \\;
I'm on a different computer, but I have a few pics in my album...
 \\;
I'm on a different computer, but I have a few pics in my album...
Elite HDF Member
Joined: Aug 2007
Posts: 4,265
Likes: 99
From: Northern VA
RE: Couple of questions on the dwg
http://www.harley-davidson.com/gma/g...bmLocale=en_US
 \\;
Says it fits 02' - 05'. \\; Typical...[:@]
 \\;
Says it fits 02' - 05'. \\; Typical...[:@]
Thread
Thread Starter
Forum
Replies
Last Post
freebyrd
General Harley Davidson Chat
13
Jul 11, 2008 06:24 AM
songsmith
Dyna Glide Models
4
Jun 27, 2008 07:51 PM
