10K Service
Thread Starter
|
Road Master
Joined: Nov 2007
Posts: 1,021
Likes: 12
From: Greene County, MS
10K Service
It's time for my 10k service. I've already changed the oil, primary fluid and transmission fluid. I also did the clutch adjustment while the primary cover was off. I adjusted the belt tension with the tool I bought from HD. Obviously I can't check the engine idle because the manual says it must be done at a HD dealership with the Digital Technician. I replaced the spark plugs and complied with the critical fastener torque checks. I removed, cleaned and reinstalled the air cleaner. I did find one of the breather tubes to the air cleaner cracked at the base a bit. I need to replace that. I still have some of the inspections to do as well as lubing the cables. I also need to do the fall away check for the steering head bearing which I am sure needs to be adjusted since I have the front end clunk even after the new washer was installed by my dealer. I'm a little worried about that procedure. Plus I need to go get a jack so I can attempt it.
One other question though...what do you use to lube the jiffy stand?
One other question though...what do you use to lube the jiffy stand?
Thread
Thread Starter
Forum
Replies
Last Post
