PCIII map needed.
Thread Starter
|
Tourer
Joined: Jul 2008
Posts: 352
Likes: 0
From: Philadelphia, PA area
I only run 93 or better Im going to have to check the bolts again I think that I torqued them to specs and used never cease but I will have to check again. Once I do that Then I will put the map back in to see if it works better.
Club Member
Joined: May 2006
Posts: 10,815
Likes: 16
From: Virginia
Add fuel to the 0% throttle position slots from about 1500 to redline and see if that helps. That's what I had to do to quiet my bad popping on decel. I'd start with 10 and keep increasing it by 10 till it gets better then fine tune it.
Club Member
Joined: May 2006
Posts: 10,815
Likes: 16
From: Virginia
Yea I added 10 at a time. It won't hurt anything it will just use more gas. As soon as the popping is reduced try lowering the numbers a little at a time till you get the lowest numbers (less gas wasted) and least amount of popping.
If raising the numbers doesn't help try going the other way and lowering them instead. If that still doesn't help you have other problems like an exhaust leak or something.
If raising the numbers doesn't help try going the other way and lowering them instead. If that still doesn't help you have other problems like an exhaust leak or something.
Road Master
Joined: Nov 2007
Posts: 883
Likes: 2
From: Irving-Texas
I used PigInaBlanket's method after reading it in another post by him, it worked great for me. I Got a map from dynojet web page and tuned it by the seat of my pants to fit n it is great. Take some time and fiddle about just save your changed map so you can revert if needed, it took me about a month to get my Fat Bob running stock pipes with no baffles to roll right but Im very happy with the end result till I get my thunderheader.
Talk about LOUD,
Talk about LOUD,
Thread
Thread Starter
Forum
Replies
Last Post
Stanger
Dyna Glide Models
1
Jul 26, 2006 08:01 PM
Anthony8858
Touring Models
0
May 25, 2006 09:20 AM
