06 dyna service manual owners
Thread Starter
|
Tourer
Joined: Dec 2005
Posts: 295
Likes: 2
From: Australia
06 dyna service manual owners
hello,can you check wether the heads have to come off to check valve clearance from top of piston to valve's for 06 SE203 or any race cam installation for that matter.cheers.still waiting for my manual to come in.My dealer says you dont have to remove heads.
Stellar HDF Member
Joined: Dec 2005
Posts: 3,234
Likes: 106
RE: 06 dyna service manual owners
You can measure the valve clearance without removing the heads.
You put the piston at top dead center. Remove the valve spring and measure the travel of the valve stem.
You put the piston at top dead center. Remove the valve spring and measure the travel of the valve stem.
Thread Starter
|
Tourer
Joined: Dec 2005
Posts: 295
Likes: 2
From: Australia
RE: 06 dyna service manual owners
hello wlbowers,with the instruction that came with the cams it states you must remove heads ,apply a thickness of clay to the top of the piston,reassemble heads to torque do two complete revolutions of motor by hand then remove heads and measure thickness of clay for clearence.grind valves if need be.
Thread Starter
|
Tourer
Joined: Dec 2005
Posts: 295
Likes: 2
From: Australia
RE: 06 dyna service manual owners
thanx guys.the heads only have to come off if u r installing high lift cams.SE203 being very mild cam does not need valve clearance checked,stock pushrods etc.Looks like we r all correct.
Thread
Thread Starter
Forum
Replies
Last Post
TruckerXbones
General Harley Davidson Chat
10
May 9, 2019 02:06 PM
misfitJason
Engine Mechanical Topics
6
Nov 22, 2015 08:33 PM
