KURY stuff
Thread Starter
|
Ultimate HDF Member
Joined: Apr 2008
Posts: 5,384
Likes: 12
From: Out on Deranged
KURY stuff
Hey dudes I installed my iso dually pegs (without switchblades) a shifter peg and brake pedal pad- all the same theme -iso-and the hand grips too! Now the hangrips were the funny part as i had never done these. the insructs said to"reccomend" placing one set of rubber spacers under the palm of your hand so I start witht the left and it goes on fine, and you have about thirty seconds where you can still move it if you fukked up . So that's all fine . i start taking the throttle side off and undo the cables like it says and get all back together again adjust my throttle/idle cables turn handlebars all good,just then i notice the two sides aren't lined up and I think AGGH you!+*&#@ dope look now what youve done! So I sit on the bike to start it and i notice my right hand automatically goes to the position with rubber inserts in he palm of my hand. DOH it was a perfect job! of course while riding your hand position will not be at idle! Whole job took about 35 minutes!
The best part is with the can. dollar fluctuations all HD prices have gone up 15%. After I picked out my stuff the sales tek said "your lucky these still have the old prices on here and I have to give you those prices , and monday the new prices will all be invoked!" LOL
But the 20$ part was now supposed to be 30$ so that means the 84 $ part ws going to be about 120$ so I saved an additional 100$ WOOHOO..
Just trying to spread the joy!
The best part is with the can. dollar fluctuations all HD prices have gone up 15%. After I picked out my stuff the sales tek said "your lucky these still have the old prices on here and I have to give you those prices , and monday the new prices will all be invoked!" LOL
But the 20$ part was now supposed to be 30$ so that means the 84 $ part ws going to be about 120$ so I saved an additional 100$ WOOHOO..
Just trying to spread the joy!
Last edited by maddghost; Apr 19, 2009 at 11:54 PM.
Road Master
Joined: May 2008
Posts: 876
Likes: 1
From: Gloucester County, Southern NJ
Nice! How do you like the Dually pegs? Did you the strirrups as well? I have all my pegs, except my mid foot pegs replaced with ISO pegs. I'm still on the fence about the dually pegs with stirrups so I've hesitated to replace the mid pegs.
Road Warrior
Joined: May 2008
Posts: 1,380
Likes: 1
From: ,,
Well your hand should remain in the same place relative to the grip anyway, no matter if you are at idle or full throttle.
Your hand relative to the bar is a different matter.
Glad to hear that you got the grips installed, enjoy them, heard a lot of good things about ISOs
Your hand relative to the bar is a different matter.
Glad to hear that you got the grips installed, enjoy them, heard a lot of good things about ISOs
Thread
Thread Starter
Forum
Replies
Last Post
