Power Commander
Stellar HDF Member
Joined: Mar 2006
Posts: 2,622
Likes: 7
From: Gulf Coast
RE: Power Commander
http://www.powercommander.com/suppinstal.shtml#Harley
http://www.fuelmotousa.com/faq
http://harleychatgroup.com/index.php...der=0&thold=-1
Hope this helps.
Tom
http://www.fuelmotousa.com/faq
http://harleychatgroup.com/index.php...der=0&thold=-1
Hope this helps.
Tom
Grand HDF Member
Joined: May 2006
Posts: 4,375
Likes: 3,759
From: SE NC
RE: Power Commander
I have an '06 superglide custom, it is a pain in theA**. so much for the 5-15 minute mounting instructions!! I was able to velcro the unit under the original ECM, the connectors I had to mount (stuff) behind the rear cylinder in front of the electrical box. just make sure it doesnt touch the exhaust or clinder head. also watch out for putting to much stress on the wires, for they may wear/vibrate and weaken connections or wear through. i also was not able to put that connector back on the electrical box that blocks that electrical box bolt. it just stays in the slot the ECM plug goes through. it took me 45-60 minutes to install. the first time is always hard to do. if i were to do it again, then it would probalby take 15 minutes or so. hope this helps, lol
Advanced
Joined: Sep 2005
Posts: 92
Likes: 0
From: Ct
RE: Power Commander
I had the same problem with my '05 Low Rider. No matter how I tried packing everything in there, (following the instructions), something would end up sticking up above the frame, so that if I installed the seat it would compress eveything. Maybe that's OK, but with only a couple hundred miles on the bike at that time I didn't want to chance it. I sold it and went with the HD download. If they come out with a more compact unit or better mounting solution I'd probably try again.
Thread
Thread Starter
Forum
Replies
Last Post
