Any pics of FXDI with 3.5" pullback risers?
Outstanding HDF Member
Joined: Jan 2007
Posts: 3,438
Likes: 3
From: Chesterfield, VA
I had some on mine, but they weren't on there long enough to get pics.
They made the stock speedo stick straight up in the air. I didn't like that look at all.
Also had to do a little bending on the steel upper sections of the brake line.
They made the stock speedo stick straight up in the air. I didn't like that look at all.
Also had to do a little bending on the steel upper sections of the brake line.
Outstanding HDF Member
Joined: Jan 2007
Posts: 3,438
Likes: 3
From: Chesterfield, VA
The angle of the speedo in the pic you provided is angled at more of an extreme than it would be with pullback risers. The stock angle is 35 degrees. With pullback risers, it probably goes to 60 - 70 degrees.
You may have seen these before. At one time i had some interest in a set till I saw the price ($150.00).
http://www.rivcoproducts.com/product...cat=286&page=1
There have been posts by guys who have used these and had fitment issues with the housing from the 06 and later speedos. If I remember correctly, a slight midification to the housing with a dremel tool corrected this. A search of "Rivco" may give better details.
You may have seen these before. At one time i had some interest in a set till I saw the price ($150.00).
http://www.rivcoproducts.com/product...cat=286&page=1
There have been posts by guys who have used these and had fitment issues with the housing from the 06 and later speedos. If I remember correctly, a slight midification to the housing with a dremel tool corrected this. A search of "Rivco" may give better details.
Last edited by jmpancoast; Dec 10, 2009 at 02:14 AM.
Thread
Thread Starter
Forum
Replies
Last Post
