Maxi Fuse Question
Thread Starter
|
Cruiser
Joined: Nov 2009
Posts: 234
Likes: 0
From: Neawark, DE
Maxi Fuse Question
I am going to install a chrome coil cover on my 2010 FXDC (no alarm system on bike). The first step in the instructions says to remove the Maxi Fuse.
Do you have to remove the maxi fuse if you don't have an alarm system?
Thanks
Do you have to remove the maxi fuse if you don't have an alarm system?
Thanks
Ultimate HDF Member
Joined: Oct 2007
Posts: 7,562
Likes: 11
From: Palm Harbor fl.
They always recommend to remove the fuse or disconnect the battery neg. terminal when working on something with wiring. Anyways, just pull the fuse, takes all of 2 seconds to do. Probably won't damage anything if you don't, but you could if you pull a geek and somehow wind up shorting out something.
Elite HDF Member
Joined: Aug 2007
Posts: 4,722
Likes: 7
Lots of stuff says to do that and I rarely do. Just make sure nothing is turned on and discharge any static electricity (it is that time of year) from your body before you go touching anything that could send it back through the system. When I installed my Kuryakyn flush mount gas gauge the other day, it said to disconnect the battery first, but I didn't. I just made sure the system wasn't on and I wasn't "charged".
I just pulled the Fuse. Can't remember I think I had to reset the clock but everything else is okay. On most things where it says disconnect the battery making sure everything else is off and pulling the maxi-fuse is enough.
Thread
Thread Starter
Forum
Replies
Last Post
