Recently purchased a 2004 Wide Glide that had the rear turn signals removed. I purchased a kit from HD that had two sets of turn signals, both front and rear. The rear lights are two wire single filament, and the front are three wire double filament. I would like to have the rear turn signals serve as both running lights and turn signals. Can I install the front signals on the rear and have both running and turn signals. I have the service manual along with the wiring diagram but unsure where I would connect the third wire in the rear tail light housing, would I splice into a wire going into the tail light. Would I be better off buying more stuff from HD and get the wiring kit that turns the rear turn signals into, running, turn , and stop.

 

Cheaper to just buy the run/stop/turn module and install the proper rear signals.

 

I believe I will take that advice.
Will install the turn signals as they should be, run for a few days, then get the Turn, run, stop thing.

Thanks

 

Dog, I sent you a PM. I have an extra one.

 

Yes you can easily do that, no need for any module if you have 3-wire signals.
You should have a black, a brown or violet, and a blue wire on the lights correct?
Black is ground, blue is tail, and the brown or violet are turn.

Do you want all 3 on each light or do you want run and turn, or stop and turn?

 

+1 on the run turn brake, I just put one on and WOW what a difference in lighting it makes. I bought the kuryakan model i wanted the pulse brake light also

Ride Safe
Pirate