Brake Lights
Thread Starter
|
6th Gear
Joined: Jul 2010
Posts: 10
Likes: 0
Brake Lights
Ok. I am new to owning a Harley. I purchased an 06 Street Bob form a repo dealer. The brake light was taken off and the turn signals have red lense covers. The brake lights are not working. I know they make a run/turn/brake module but i don't know if it has one installed. I would think that the previous owner would have had it converted considering this state has inspections. So how would I tell if it has one? Also when I lifted seat there is a black ground wire and red wire with inline fuse that has been cut...have no clue what this goes to. Any help and pics would be appreciated. Like I said..I am a newby and I am learning..Thanks
Tourer
Joined: May 2009
Posts: 310
Likes: 0
From: Des Moines, IA
If there is a run/turn/brake module, it'd likely be under the seat, connected to the wiring that runs into the rear fender to the tail/turns. I don't really know where else it would be placed, and it should be fairly obvious. Lots of companies make the modules (not just H-D) but as far as I know they're all black rectangular plastic boxes.
Don't know what the red wire would go to. License plate lighting, perhaps?
Don't know what the red wire would go to. License plate lighting, perhaps?
Thread
Thread Starter
Forum
Replies
Last Post
