help! won't start
Thread Starter
|
Intermediate
Joined: May 2010
Posts: 44
Likes: 0
From: Murrieta, CA
help! won't start
Looking for a hand on this, here's the background story. I spent the weekend installing d&d fat cat, zippers hi-flow ac and thundermax w/ auto tune on my 2010 fxdwg. I got into some trouble with the software connecting to the ecm but i finally got the module linked and wrote the base map to it. Initialized the ecm and when i tried to start the bike i get a check engine light and "tIP" shows on the speedometer. can't figure out what this means or how to correct it. can't wait to get the bike running and take her out for a spin, any help would be great.
Supporter
Joined: Jan 2007
Posts: 15,788
Likes: 5,622
From: along the shore of Mishigami
There is a way to retrieve that information thru your ignition, unfortunately I don't have it. May I suggest posting this inquiry on the General forum. There are a couple of people who have a list of codes and what they mean on that forum.
Thread Starter
|
Intermediate
Joined: May 2010
Posts: 44
Likes: 0
From: Murrieta, CA
Thanks for the tips. the computer was telling me the bike got tipped over or leaned too far but that wasn't the case. it was because all the parts were out of the derby cover during the tmax install so the bike thought it was leaning too much or had been tipped over. i put all the parts back in place and the tip error disappeared. 
Thread
Thread Starter
Forum
Replies
Last Post
tennman0258
Ignition/Tuner/ECM/Fuel Injection
4
Oct 14, 2014 07:09 AM
