Points Cover Screws
Thread Starter
|
Cruiser
Joined: Nov 2010
Posts: 159
Likes: 0
From: Tampa, FL
Points Cover Screws
Hey guys last night I replaced my screaming eagle points cover with a dark customs skull logo cover and when i went to put the screws back in they dont seem to tighten up. The 4 of them start to snug then release right after. So i turned those to where they start to snug and leave them there. But one of the bottom screw doesn't even do that, so it just spins. This makes absolutely no sense. Any ideas on this?
Thread Starter
|
Cruiser
Joined: Nov 2010
Posts: 159
Likes: 0
From: Tampa, FL
by the way Joe, I have admired your scoot for quite a long time before i even owned a Harley. Well done brother!
Road Warrior
Joined: Jul 2010
Posts: 1,645
Likes: 1
From: Orangetown, NY
Same thing happened to me when I switched out my timer cover to the black fin timer cover. Went to moco and they had the the longer screws to attach cover. Ridiculous aint it! I think it cost me 4 bucks
Thread Starter
|
Cruiser
Joined: Nov 2010
Posts: 159
Likes: 0
From: Tampa, FL
you know its funny. I looked at the package the cover came in and it has that compartment in the back where screws would go. And I thought to myself, now why wouldnt they just throw some screws in there? Anything to make a buck i guess.
Outstanding HDF Member
Joined: Jun 2007
Posts: 2,796
Likes: 36
From: Toronto, Ontario
.
Thread
Thread Starter
Forum
Replies
Last Post
