Burly slammer kit
Thread Starter
|
Road Master
Joined: Mar 2008
Posts: 871
Likes: 0
From: ohio
Burly slammer kit
My slammer kit finally arrived today for the 11 streetbob, but the instructions call for fork tube dissassembly because the short springs go on the bottom of the damper rods?
I f you pull em down that far you will need to pull the seal and bushings out, yet their instructions dont mention this.
its no big deal but i will need the seal driver and fork oil on hand, i was under the impression that this was a drop the springs in and go.
So i may not get to it this weekend
Anybody been there done that?
I f you pull em down that far you will need to pull the seal and bushings out, yet their instructions dont mention this.
its no big deal but i will need the seal driver and fork oil on hand, i was under the impression that this was a drop the springs in and go.
So i may not get to it this weekend
Anybody been there done that?
Thread
Thread Starter
Forum
Replies
Last Post
Fusionfool
Tri Glide, RG3 & Freewheeler Models
0
Sep 16, 2015 09:57 AM
yzernie
Frame/Suspension/Front End/Brakes
0
May 27, 2015 08:47 PM
