2010 FXDB rear signal issues
Thread Starter
|
Stage IV
Joined: May 2012
Posts: 4
Likes: 0
From: Joplin, MO
2010 FXDB rear signal issues
I have taken off my stock turn signals and replaced them with after markets that are smaller. They are not run stop/turn signals like the stock signals, meaning they only have two wires instead of three. When I wire them I leave the blue wire undone so that they will act as turn signals and not brake lights. However, when I have both signals wired up (and only one signal turned on)they along with the tail light all blink at once a few times, then the taillight stops blinking, and the turn signals continue to act as hazard lights even though only one signal is supposed to be on. Any ideas anyone?
Thread
Thread Starter
Forum
Replies
Last Post
