my 08 fxdb project so far........
Thread Starter
|
Advanced
Joined: Sep 2009
Posts: 87
Likes: 0
From: aurora, co
what a busy monday!
started off at school from 7-11 am learning how to drive this beast
its a blast, i cant wait to get to work driving one, hopefully make some real money!
then i headed to one of my brothers house where i store my bike, got started on my primary cover. i traded with the parts guys at the stealership. my chrome primary and derby cover for factory wrinkle black stuff. old vs new:
then we decided to unwrap my national cycle hand guards, i went with the ones for a bagger cause they are significantly bigger. its gets damn cold riding in colorado and i need as much hand protection as possible. i proceeded to hang them and plasti-dip them.
i then installed them on the bike, i didnt like the way they looked with the stock front signals, i had some 3wire amber led strips laying around, so i cut them down and soldered them and stuck them to the trim plate on the handguards:
we then pulled the bikes out of the garage(it was 45 and sunny) to install some coilovers on my bros gti. opened the garage 2 hours later and were suprised by this
on the way home i stopped at the local ghetto store and picked up some fresh gear
all in all a nice little day wrenchin with my brother, the wife didnt bitch when i got home, but she also didnt give up any ******...........so lets just call it a decent day.
cheers.
started off at school from 7-11 am learning how to drive this beast
its a blast, i cant wait to get to work driving one, hopefully make some real money!
then i headed to one of my brothers house where i store my bike, got started on my primary cover. i traded with the parts guys at the stealership. my chrome primary and derby cover for factory wrinkle black stuff. old vs new:
then we decided to unwrap my national cycle hand guards, i went with the ones for a bagger cause they are significantly bigger. its gets damn cold riding in colorado and i need as much hand protection as possible. i proceeded to hang them and plasti-dip them.
i then installed them on the bike, i didnt like the way they looked with the stock front signals, i had some 3wire amber led strips laying around, so i cut them down and soldered them and stuck them to the trim plate on the handguards:
we then pulled the bikes out of the garage(it was 45 and sunny) to install some coilovers on my bros gti. opened the garage 2 hours later and were suprised by this
on the way home i stopped at the local ghetto store and picked up some fresh gear
all in all a nice little day wrenchin with my brother, the wife didnt bitch when i got home, but she also didnt give up any ******...........so lets just call it a decent day.
cheers.
Thread
Thread Starter
Forum
Replies
Last Post
