run/turn/brake module
Thread Starter
|
Novice
Joined: Jun 2012
Posts: 19
Likes: 0
From: Saskatchewan
run/turn/brake module
I have been researching the run/turn/brake modules available as I want to bob my rear fender and lose my 2008 streetbob's tail light.
Do I have to modify or change up the existing run/turn lights to a dual filament socket and bulb? I apologize if I am beating a dead horse but I haven't found any answers.
Do I have to modify or change up the existing run/turn lights to a dual filament socket and bulb? I apologize if I am beating a dead horse but I haven't found any answers.
Devil's Advocate
Joined: Jun 2010
Posts: 2,070
Likes: 36
From: Alberta, Canada
Badlands sells a good module for that, but not sure what happens if you remove the tail light. I just ordered the lowest profile tail light (sticks out about an inch) I could find with turn signals integrated so that I can loose my turn signals.
Road Master
Joined: Mar 2011
Posts: 990
Likes: 8
From: CALIFORNIA
I have been researching the run/turn/brake modules available as I want to bob my rear fender and lose my 2008 streetbob's tail light.
Do I have to modify or change up the existing run/turn lights to a dual filament socket and bulb? I apologize if I am beating a dead horse but I haven't found any answers.
Do I have to modify or change up the existing run/turn lights to a dual filament socket and bulb? I apologize if I am beating a dead horse but I haven't found any answers.
Thread
Thread Starter
Forum
Replies
Last Post
LooseMoose
Softail Models
5
Mar 8, 2010 12:00 PM
RKTonyC
Ignition/Tuner/ECM/Fuel Injection
1
May 27, 2009 08:11 PM
Anothernewguy
Ignition/Tuner/ECM/Fuel Injection
5
Feb 25, 2006 09:36 PM
