Rear Fender Mod
Thread Starter
|
3rd Gear
Joined: Jun 2012
Posts: 7
Likes: 0
From: Midwest
Rear Fender Mod
So I have my new fender painted and installed. Now I'm trying to figure out how to get the wires from the turn signals that used to go to the tail light assembly, routed up forward to the main harness. I have them running through the rubber conduit on the inside of the fender but the section between the turn signal mount and the end of the tube I don't like. I epoxied another plastic tube to run the wires through that short section but still it just seems a poor way to do it. Anyone have a better idea?
Stellar HDF Member
Joined: Sep 2012
Posts: 2,099
Likes: 214
From: Delawere
I use these to secure alot of mine..Like the tag light wire that runs down the swing arm.
Their 1"X 1" but can be cut down.Held by double sided tape and are used w/a small zip-tie.(Home Depot)
Their 1"X 1" but can be cut down.Held by double sided tape and are used w/a small zip-tie.(Home Depot)
Thread
Thread Starter
Forum
Replies
Last Post
FBFletch
Ignition/Tuner/ECM/Fuel Injection
5
Dec 23, 2020 02:17 PM
