i want to put some Z-bars on my Superglide, but I want to use all my existing wires and cables. is there such a beast out there?

 

I'm not a mechanic or anything, but the stock HD bar stats are below. Compare the rise, pullback, and tip to tip dimensionsonyourstock barsto the Z-Bars. If the Tip to Tip measurementis less, you may gain some slack in your wires/cables. I know my wires and throttle/idle cablesare laking in slack.





Part Number
Tip to Tip
Base Width
Rise
Pull Back
Knurl
Center to Center




56085-83A
31"
7.75"
4.5"
5.75"
3.14"

56085-83T
31"
7.75"
4.5"
5.75"
3.14"

 

thanks. i have been looking all over for those specs, short of actually measuring the bars myself.
i'll have to post a pic once i have them installed. thanks again.

 

Paughco makes a Z-bar in several different heights. 4" would probably be what you want.

http://www.paughco.com/2003_catalog/page33.htm


PsTaN

 

You can buy my bars. There are completely unused and have never left my house since I got them in the mail. I paid $150 for them total from Lick's Cycles. Make me an offer.

http://www.lickscycles.com/catalog/p...oducts_id=1180

 

I have seen these pictures before and now I just gotta ask... What the he11 is up with the lines going from the where the knurls end to where the controls stop? ? ?

 

That's how they were shipped to me. They've been on there since I opened the package. I assumed they were there to help pull the wires through.

 

those are going to be to high of a rise for me.i want a low profile bar that i will be able to use my stoock wiring and cables. i did find a pair, just got to put them on order. thanks guys for all of the help. ill have pics up one day.

 

yep..pull-strings was my guess as well