Hi.
On the SB2013, almost all handlebar controls are 'multiplexed' :
turn left + Trip + Horn + Hi-Low light (+ clutch switch ?) = 1 pair of twisted cables
turn right + kill + start + warnings (+ brake switch ?) = 1 pair of twisted cables

I'd like to relocate some of the functions somewhere else on the bike... and keep only a few of them on the bars (turn left and right for sure, maybe horn and 'kill')

Any ideas ?

 

You could drill the bars you have or get a set of bars set up to run the wires internally. That way you dont have to relocate anything and the wire problem is solved!

 

Hi Leans.
The problem is not to run the cables internally, it is already done...
the problem is that there is only one cable (pair of twisted cables) for several functions, and I want to relocate only some of them.
I have to 'demux' the signals...