Double sided 3m tape for saddlebag turn signals
Thread Starter
|
Road Master
Joined: May 2008
Posts: 1,232
Likes: 427
From: Northern NY
Double sided 3m tape for saddlebag turn signals
I looking at a set of slightly used, OEM Harley Signature LED lights for the rear of the saddlebags on my RGS. Anyone know what type of tape the use on them when new? Thickness and strength is what I'm looking for. Would like to use the same stuff so I could get them off if desired for paint etc.
Thanks
Thanks
Seasoned HDF Member
Joined: Nov 2018
Posts: 10,833
Likes: 6,485
From: Canada Flats
Best thing to use would be this . They offer different width's as well , not sure what size of lights your putting on .
Thread Starter
|
Road Master
Joined: May 2008
Posts: 1,232
Likes: 427
From: Northern NY
Best thing to use would be this . They offer different width's as well , not sure what size of lights your putting on .
https://www.amazon.ca/HitLights-Heav...2s9dHJ1ZQ&th=1
https://www.amazon.ca/HitLights-Heav...2s9dHJ1ZQ&th=1
Thread Starter
|
Road Master
Joined: May 2008
Posts: 1,232
Likes: 427
From: Northern NY
can you get the Very High Bond tape off if needed w/o hurting the paint?
Banned
Joined: Aug 2021
Posts: 4,027
Likes: 6,286
From: SoCal
Yes. Solvent such as WD-40 will dissolve the adhesive and leave the paint unharmed, but it is intended as a semi-permanent solution.
Thread
Thread Starter
Forum
Replies
Last Post
mxz600
Sportster Models
18
Jul 23, 2009 02:47 AM
