turn signal relocation/ springer flstb
Thread Starter
|
Intermediate
Joined: Jun 2010
Posts: 25
Likes: 0
turn signal relocation/ springer flstb
i bought a front turn signal relocation bracket from jp cycles and it says to mount to the spring reaction bracket but has no instructions. anyone done this install or can attach a pic of where they have thiers mounted?
Road Warrior
Joined: Dec 2011
Posts: 1,805
Likes: 47
From: Lake Tahoe California
I just relocated my turn signals the other day. I made my own mounts. Easy peasy. I just got a couple three inch braces from the hardware store (the type with only two holes). I drilled out the holes with a 5/16" bit. I then got two 5/16-24 (fine thread) by 1/2" button head bolts. I mounted the stock turn signals to the brackets using the button-head bolts, and then mounted the brackets to the forks. I used the bolt on the forks that usually hold the brake line and throttle cable guide (and its twin on the other side) to hold the brackets. Quick, invisible, and cost less than $5.
Close-up:
A little farther away:
View from the front:
The extra cable I gathered, and tucked between the frame and the tank on the right side.
Close-up:
A little farther away:
View from the front:
The extra cable I gathered, and tucked between the frame and the tank on the right side.
Thread
Thread Starter
Forum
Replies
Last Post
gearhead1937
Want To Buy Motorcycles/Parts/Accessories
0
Oct 31, 2013 12:12 PM
bracket, davidson, flstb, forums, harley, mount, reaction, relocaters, relocation, relocators, signal, signals, spring, springer, turn, windscreen
