Custom Dynamics Plasma Rods and EPZ2
Thread Starter
|
Stage IV
Joined: Nov 2013
Posts: 4
Likes: 0
From: USA
Custom Dynamics Plasma Rods and EPZ2
Having trouble with a simple installation of Plasma Rods on a custom bagger. I want to use EPZ2 module and plasma rods to run as Brake/Turn.
Individually, brake works, turns work. It was my understanding from CD website that turn would take priority over brake using the EPZ2. Turn side should blink while opposite side stays lit solid as long as brake is applied. The opposite happens, when turn signal is activated and blinking and brake is applied all go solid. When brake is released turn resumes blinking. Any wiring insight?
Current hookup according to CD instructions-
EPZ2 output red and black to Plasma red and black
EPZ2 input red to brake/Orange to turn (purple left/brown right)/black to ground.
Thanks!
Individually, brake works, turns work. It was my understanding from CD website that turn would take priority over brake using the EPZ2. Turn side should blink while opposite side stays lit solid as long as brake is applied. The opposite happens, when turn signal is activated and blinking and brake is applied all go solid. When brake is released turn resumes blinking. Any wiring insight?
Current hookup according to CD instructions-
EPZ2 output red and black to Plasma red and black
EPZ2 input red to brake/Orange to turn (purple left/brown right)/black to ground.
Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
Mark (Rooster)
Tri Glide, RG3 & Freewheeler Models
7
May 14, 2015 12:17 PM
