PCV Map Request - 117"
Thread Starter
|
Supporter
Joined: May 2012
Posts: 1,309
Likes: 12
From: Monroe, NC
PCV Map Request - 117"
Looking for a PCV map for a 117 engine I purchased.
S&S 10.5:1 Flat top pistons
T-Man 625 Cams
SE 110 heads with Dorfman porting
58mm SE TB
Cobra Power Port Dual headpipe with Cobra 909 mufflers
S&S 10.5:1 Flat top pistons
T-Man 625 Cams
SE 110 heads with Dorfman porting
58mm SE TB
Cobra Power Port Dual headpipe with Cobra 909 mufflers
May want to have that bad boy treated to a proper dyno tune. As far as a map request you might be without much help using the pcv. Hope someone else chimes in. If you bought the pcv from fuelmoto they will help you out.
Ultimate HDF Member
Joined: Nov 2005
Posts: 5,926
Likes: 138
From: NE Ohio
Do yourself a favor and take it to a competent tuner to get it tuned. You can kill a big engine quick if it isn't tuned correctly right from the beginning. When I built my 120 I used a map that was kind of close just so I could start it and make sure it would run. Then it was pushed into the trailer for a 500 mile ride, then right onto the dyno to be heat cycled, broken in and tuned.
Thread
Thread Starter
Forum
Replies
Last Post
bobby5
Ignition/Tuner/ECM/Fuel Injection
2
Jun 3, 2010 04:03 PM
