Which ring compressor tool are yall using?
No Junk china crap
a good quality tool that will last even though I may only use it a few times

Thanks

 

I've had my Snap-On ring compressor for about 40 years ... Many many engines have been assembled with it.

 

I used this a few times, just keep it stored in a Ziploc​ so it doesn't rust in storage.

https://m.summitracing.com/parts/lil-21700?seid=srese1&cm_mmc=pla-google-_-shopping-_-srese1-_-lisle&gclid=CMWn2MTm7dMCFRi4wAodpB0JrA

 

i've been using this, but i install my pistons in my cylinders first, then connect them to rods.

https://www.harborfreight.com/4-inch...sor-97709.html

 

I have a Craftsman I bought new over 40 years ago, bet it lasts another 40 years if my daughter takes care of it, since there's not much chance I'll last that long.