Feuling hp+ preload
Thread Starter
|
Stellar HDF Member
Joined: Mar 2015
Posts: 2,941
Likes: 995
From: Winnipeg
Feuling hp+ preload
Installed a set of these when I did a cam upgrade to Andrews 48. Feuling recommended .90 to .100 preload , however many more experienced members suggested more in the .140 to .150 range (at least with s&s, Johnson etc they did) Following that I adjusted to .131 on SE tapered PRs. Bike runs fine but does have that whiney sewing machine sound at the 2000 rpm range.
I never noticed that before the install.
is that just a byproduct of the cam and lifter change or should I have followed feuling and left it at .100?
I thought .131 was a good middle ground
I never noticed that before the install.
is that just a byproduct of the cam and lifter change or should I have followed feuling and left it at .100?
I thought .131 was a good middle ground
Thread Starter
|
Stellar HDF Member
Joined: Mar 2015
Posts: 2,941
Likes: 995
From: Winnipeg
Great thanks EJ. Im right in the middle of that range so all is good.
Tourer
Joined: Jul 2014
Posts: 426
Likes: 157
From: Lake Wales, Fl
You are welcome Sir - With their Race lifters Feuling says .100 & no more , with the HP 4000 it's OK
Thread
Thread Starter
Forum
Replies
Last Post
