Hello team Evo,

A few years ago I moved and misplaced the trap door to the red motorcycle table lift. Would somebody please measure it and post it up? I'm guessing it is easier to buy a sheet of diamond plate and cut it versus calling hf and trying to buy it there.

Obviously I can measure the hole myself but I think it was oversized. Longer or wider??

Tia!

 

I don’t have the measurements but I have actually ordered parts through HF and it was super easy and efficient.
i boogered up a slide on my 56 inch tool chest, and thought the same thing, but they had the parts and shipped it right out, price was decent also.

 

That part is not listed.

Replacement Parts

 

I'm away from home now, or I'd go measure mine.

If nobody gets this info to you by early this evening, I'll do it when I get home.

 

please do if you remember. Thx

 

I don’t know if your HF table and mine or the same or not, but my trap door is not oversized, but fits in the opening and rests on steel flat bar stock spot welded from underneath, making it flush with the rest of the table.

 

GalvTexGuy is correct. There are "lips" that it sits on and it's flush with the rest of the table top.


You can see the three lips on this end of the hole, there's another lip across the other end of the hole.

My cover for the hole measures 29 15/16 long by exactly 11 inches wide.

 

outstanding!

I love the Evo sub forum. It's the best!

Thank you,
Tom

 

FYI, here’s what the trap door looks like.

 

Mine doesn't have the lips, lol....
I looked at a few of the other pics on this forum and the random web pics, it looks like some of them are actually oversized. This thing was like $299 with a coupon 13 years ago so it's been a good investment. So I think that I'll start with a slightly larger piece versus trying to make a perfect piece.
always something, right?!?!