96 FX Springer front fender mounting help!
Thread Starter
|
Road Captain
Joined: Jun 2006
Posts: 527
Likes: 1
From: North Vernon, Indiana
96 FX Springer front fender mounting help!
My father in law bought a used 96 Springer recently. One of the "pivot shafts" that screw into the fork leg was coming out so we took fender off to investigate and looks like whoever painted the bike didnt put it back together right with the proper spacers and washers where needed. Any one with a exploded view from a manual showing ALL the parts required to do it right? Pivot shafts screw into leg..there is a chrome dog bone that slides over the shafts with a rubber seal, and go up to a bolt that goes thru the dog bone and fender. This is on each side. THEN there is the fender mount down at the brack caliper . Some washers and spacers etc down there that appear to be missing too..
Any help in a exploded pic or view would be greatly appreciated! Email me at jrudicel@hotmail.com
Any help in a exploded pic or view would be greatly appreciated! Email me at jrudicel@hotmail.com
Seasoned HDF Member
Joined: May 2005
Posts: 10,232
Likes: 9,322
From: Georgia
I believe there is one nylon and one thin metal one down there with the steel pivot shaft if I remember correctly.PM me your e mail and when I get home tomorrow I'll scan the page out of the manual.Posting manual pages on here is not allowed.
Thread
Thread Starter
Forum
Replies
Last Post
mr1gebby
Softail Models
12
Dec 22, 2010 02:28 PM
