Last night while I was putting my bike back together after the motor rebuild, my choke assembly broke. I pushed the carb into the intake and tried to install the choke in its mount by the horn. I was tightening the nut behind the mount and the plastic threaded sleeve cracked. I didn't think I was using much force at all. Guess I was wrong. Anyway, I've done a quick internet search and cannot find a new choke assembly for a CV carb. I saw several for the Mukuni, none of what I need. Can you guys point me in the right direction on where to get one before I have to take it to the dealer, and I'd rather not have to go there. Thanks

 

I got mine at Bud's Motorcycle Shop in Austin TX.

 

http://www.amazon.com/Bikers-Choice-.../dp/B0012TRLBO

Check the application.

 

Try your H-D dealer....and that nut is not like a real nut, it doesn't take much to crack it.

 

I've got one from Drag. The part number is 0654-0025.

 

Thanks guys, I'll check out the part #, and probably end up at the dealer (need some other stuff too). Right on about about that nut. I was using my fingers to tighten it when it cracked. It was probably already cracked cuz I doubt I'm that strong.

 

They get brittle with the heat

 

The Mikuni cable will work if it is the right length!!

 

Miacycles, have you actually installed the Mikuni enricher on/in a Harley CV? I need a new enricher assembly and like the Mikuni's better quality, not to mention two less parts needed to install.

 

The two are different lengths but both run off the H-D cable.