locating a tool
Thread Starter
|
Road Master
Joined: Aug 2005
Posts: 1,203
Likes: 7
From: Bedford , Pa
locating a tool
I saw on the touring section a guy makes a tool to remove inner cam shoe without removing cams. Who makes this tool and where can I buy one..Anybody know Thanks in advance
Road Warrior
Joined: Jun 2016
Posts: 1,751
Likes: 263
From: Catalina AZ
If it's the same video I watched before I did mine.... he makes the tool.
Or you can make your own.
I was going to make my own but a buddy came over and showed me how easy the cams pop out.
So that's how I ended up doing mine.
Just pulled up you tube and found a new tool:
tool: TC88 1999-2006
Tool is hand made in the USA in small batches and may not always be in stock ready to ship. Inquiries: holescreek@yahoo.com
Cooler than the one I saw back when I did mine.
Or you can make your own.
I was going to make my own but a buddy came over and showed me how easy the cams pop out.
So that's how I ended up doing mine.
Just pulled up you tube and found a new tool:
Tool is hand made in the USA in small batches and may not always be in stock ready to ship. Inquiries: holescreek@yahoo.com
Cooler than the one I saw back when I did mine.
Last edited by GRWHD; Mar 21, 2017 at 07:14 AM.
Seasoned HDF Member
Joined: Aug 2011
Posts: 11,814
Likes: 5,120
From: SW Ohio
The sellers contact information is listed in the comments section of the video. That tool will allow you to remove the secondary tensioner without removing the cams from the plate.
Thread
Thread Starter
Forum
Replies
Last Post
obd2works
General Topics/Tech Tips
0
May 31, 2014 04:00 AM
