Trying to get back in
Thread Starter
|
Novice
Joined: Apr 2013
Posts: 15
Likes: 0
From: livermore ca.
Trying to get back in
Morning everyone. I'm new and need some help getting back into wrenching on my own bike.
My current problem is ( from what the HD Mech said ) is my "shift seal " is in need of repair. learned that after replacing my primary cover gasket and new fluid a couple of days ago , went for a ride and looked down and was still leaking.
Happened to be at a Chili cook off in Jamestown Ca. So asked the HD Mech. for a'lil help, he was too.
Are there any tips & tricks that can make this task a"lil easier to do.
Thanx
LIVINFREE
My current problem is ( from what the HD Mech said ) is my "shift seal " is in need of repair. learned that after replacing my primary cover gasket and new fluid a couple of days ago , went for a ride and looked down and was still leaking.
Happened to be at a Chili cook off in Jamestown Ca. So asked the HD Mech. for a'lil help, he was too.
Are there any tips & tricks that can make this task a"lil easier to do.
Thanx
LIVINFREE
Outstanding HDF Member
Joined: May 2013
Posts: 2,059
Likes: 4
From: Florida
Thread
Thread Starter
Forum
Replies
Last Post
