Craftsman Torque Measurement System..Anyone?
Banned
Joined: Jun 2005
Posts: 6,982
Likes: 1
From: Polygamy Plains, Utah
RE: Craftsman Torque Measurement System..Anyone?
I haven't. BUT, with my experience with torque wrenches, my personal ones, and the ones I have calibrated for military and civilian customers for the last 25 years... I would trust it. Never have known a Craftsman torque item to be lousy. The specs sound good too.
Thread Starter
|
6th Gear
Joined: Mar 2006
Posts: 10
Likes: 0
From:
RE: Craftsman Torque Measurement System..Anyone?
Thanks LRonHoover……..That gives me some confidence…….Got to go about 50 miles to get one chop, chop or Internet order and I just detest a extra trip for exchange. I’ll get back to this thread in a couple of days with a review….
Mahn… like your signature
Peace
John
Mahn… like your signature
Peace
John
Thread Starter
|
6th Gear
Joined: Mar 2006
Posts: 10
Likes: 0
From:
RE: Craftsman Torque Measurement System..Anyone?
skos.... Thanks Mahn for the reply, however that was on the 20th of last month and i can now say it works great..... I don't intend this hurtfull but these forums are not very chop chop with replies are they?
Disappointed member
CM
Disappointed member
CM
Seasoned HDF Member
Joined: Dec 2004
Posts: 7,934
Likes: 43
From: Bloomfield, NM
RE: Craftsman Torque Measurement System..Anyone?
ORIGINAL: cowmobile
skos.... Thanks Mahn for the reply, however that was on the 20th of last month and i can now say it works great..... I don't intend this hurtfull but these forums are not very chop chop with replies are they?
Disappointed member
CM
skos.... Thanks Mahn for the reply, however that was on the 20th of last month and i can now say it works great..... I don't intend this hurtfull but these forums are not very chop chop with replies are they?
Disappointed member
CM
Regards,
Bill
Thread
Thread Starter
Forum
Replies
Last Post
