pull last program from vci module
Thread Starter
|
Road Master
Joined: Dec 2008
Posts: 872
Likes: 20
From: Niagara Falls Canada
pull last program from vci module
I had to reload my laptop and dont have the last program that i loaded in to my bike. Im doing a pipe swap and think my last load had my monster rounds in the load, I want to see the ve table flows, I have stock pipes on just did a smart tune run so I can lok at how much less flow i get, I grabbed a set of 2014 cvo pipes off ebay for 231 on sunday and want to do a smart tune run to compare all the ve table.
the only problem is I forget how to draw an old program back from last load on vci. I did it once before to check a dyno tuners data, was a map from race tuner no timing changes or ve changes what a waste of money that was.
anyway some one remember how to do this
the only problem is I forget how to draw an old program back from last load on vci. I did it once before to check a dyno tuners data, was a map from race tuner no timing changes or ve changes what a waste of money that was.
anyway some one remember how to do this
Ultimate HDF Member
Joined: Dec 2010
Posts: 7,776
Likes: 2,252
From: wet coast BC
I had to reload my laptop and dont have the last program that i loaded in to my bike. Im doing a pipe swap and think my last load had my monster rounds in the load, I want to see the ve table flows, I have stock pipes on just did a smart tune run so I can lok at how much less flow i get, I grabbed a set of 2014 cvo pipes off ebay for 231 on sunday and want to do a smart tune run to compare all the ve table.
the only problem is I forget how to draw an old program back from last load on vci. I did it once before to check a dyno tuners data, was a map from race tuner no timing changes or ve changes what a waste of money that was.
anyway some one remember how to do this
the only problem is I forget how to draw an old program back from last load on vci. I did it once before to check a dyno tuners data, was a map from race tuner no timing changes or ve changes what a waste of money that was.
anyway some one remember how to do this
Thread
Thread Starter
Forum
Replies
Last Post
