Carb question
Thread Starter
|
Road Master
Joined: Oct 2007
Posts: 1,213
Likes: 1
From: Hot Springs Village AR
Carb question
I have a 1983 xls that I am working on and the inlet for the gas is broken off, can I replace this or do I need a new carb. I have seen inlet sold in after market catalogs but how do you get the old one out its plastic to
Common problem. I have not had it myself. But i believe you just remove the remains of the old one and press in the new one.
Best to get some technique from someone who has done it before. Ask here ...
http://xlforum.net/vbportal/forums/forumdisplay.php?f=7
Best to get some technique from someone who has done it before. Ask here ...
http://xlforum.net/vbportal/forums/forumdisplay.php?f=7
Outstanding HDF Member
Joined: Oct 2007
Posts: 3,450
Likes: 4
From: El Cajon Ca.
Very common. Dig out the old and press in the new while supporting the carb. And be careful. If it's a tight fit put the new fitting in the freezer for a few hours. If you search the net you will find directions.
Thread
Thread Starter
Forum
Replies
Last Post
