oil pressure/genorator indicator dash lights
Thread Starter
|
Cruiser
Joined: Dec 2009
Posts: 198
Likes: 4
From: Texas
oil pressure/genorator indicator dash lights
Can I wire in the oil/genorator lights without a lot of hassel and ****? AND is it possible to substitute my owm bullbs such as LED's and also mount in a dif location ?
Yes and yes.
The oil light has a single wire that runs from the pump up to the bulb on one side, and a 12 volt source for the other side.
The gen light has a single wire that runs from the A terminal of the gen up to the bulb on one side, and a 12 volt source on the other.
You can use the same 12 volt wire for both, with a Y-connector.
Stock wire colors are orange for the 12 volt, tan for the gen lite, green for the oil light.
The oil light has a single wire that runs from the pump up to the bulb on one side, and a 12 volt source for the other side.
The gen light has a single wire that runs from the A terminal of the gen up to the bulb on one side, and a 12 volt source on the other.
You can use the same 12 volt wire for both, with a Y-connector.
Stock wire colors are orange for the 12 volt, tan for the gen lite, green for the oil light.
Thread
Thread Starter
Forum
Replies
Last Post
