Hey, can anyone give me some info on getting that S&S cam to work on the FP3. I had a look at the list of cam options and its not there. Is there another cam that’s similar that I could select.

A lot of the cams listed are one for TC engines and the manual add only allows for intake open and closing info.

Cheers, Dave

 

Fuelmoto sell this cam so guessing they should be able to supply a tune for you

 

Hey Loopty, or anybody else out there running the 465. Id like to get a little info on where the 465 starts to come and where its done. I like the seat of the pants dyno myself. Im running SE air, SE smart tune, vance&hines power duals and eliminator 400 mufflers. Want to have a cam in for the spring, since the year is over here. Id also like to get some info on the andrews 462 if anyboby out there is using this cam.
Thanks in advance.

 

I don't have this cam but have been researching cams. I was on the s&s website and it looks like this cam comes on around 3k rpm but loses down low torque but like I said I haven't got any experience with this cam. FuelMoto has lots of dynos to look at

 

Ya, thanks jd. Ive looked at a lot of dyno sheets. i just looking hear from somebody with experience with that cam. I was under the impression with the specs that cam had, it was more of a grunt cam and would have come to life earlier

 

strike that i was looking at the 475c the 465 does give more power down low.