inner primary cover
Thread Starter
|
Advanced
Joined: Nov 2006
Posts: 65
Likes: 0
From: Dallas
inner primary cover
Here I go again back to the old shovel.The starter housing holes in the inner primary are stripped out.Debating to try to helicoil or try to find another cover.Any body have any other ideas or a cover?
Road Master
Joined: Jun 2008
Posts: 1,078
Likes: 39
From: NW Florida
helicoils should work. My early cover had studs on the inner primary. My later model cover had a front bolt that went from the inside to the housing and a bolt on the outside rear. Maybe you could helicoil the holes then use studs with locktight to hold them.
Road Master
Joined: May 2007
Posts: 953
Likes: 8
From: Central Oregon
Yes heli-coils and studs should do the trick with stud lock tight clean the studs and thread in the primary well and there is also a primer for the lock-tight for added insurance they will stay put.
I have studs on my 68, makes it nice to install the housing and start the nuts.
I have studs on my 68, makes it nice to install the housing and start the nuts.
Thread
Thread Starter
Forum
Replies
Last Post
