Here is where it begins...



I have added a chrome adjustable swingarm, but not satisfied with the axle fitment yet...the quest continues.



Trial fitting of a bobbed stock fender shows that I must do some minor trimming of the left strut spacers to get it flush with the fender side.





Next up is fitting of a new tail lite. I had to drill for this one as the fender was blank.







I know how you guys like pictures, so I will post them with every update. Upcoming will be fitting of a new fuel tank and possibly a WG replacement for the current springer.

 

Nicely done man clean work and I do like seeing that , should see some the monkeyed up stuff I get to straighten out sometimes makes you wanna cry .

 

Raining here, so I decided to remove the old tank and set the new one up just to get a feel for the upcoming look...

 

looking good.
any plans for your old tins?

 

Thanks - Going to put them away for another day.

 

Axle issues resolved and another caliper bracket installed so I can run a bottom mount caliper. Have yet to find a source for various thickness 3/4" ID axle spacers tho...

 

Source found for axle spacers that can also be purchased individually... http://cgi.ebay.com/ebaymotors/Wheel...item2c5e2d092e

New nickle plated RevTech o-ring chain...looks great once you get all the excess grease off of it.

 

Ended up replacing everything from the MC back with the new caliper...will be much cleaner looking when finished.

 

I use these place's a lot for that kind of stuff , I have a nice assortment of spacers & shims both internal and outer plus BikerGarage is great source for all kinds of little odds & ends you always need during any kind of build or mod work .

http://www.jirehcycles.com/

http://www.bikergarage101.com/servlet/StoreFront

 

Thanks TwiZted, I'll bookmark those links.