When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I was doing a quick check before leaving work the other morning and noticed my brake lights and running lights were out. Pretty scary because I have to do a 5 mile stretch on I-95 at 6AM with a bunch of half asleep people rushing to work. I checked and the hazards worked so I turned them on.
I haven't had much time to check it yet but I did pull the seat and look around. I see no bad wires. Everything is plugged in. I have power to the orange wire at the plug that goes under the fender. When I put the turn signal on to check for power the brake light and both turns signals flash. Thats as far as I got.
I have a brake/run module in the mix, and a BAL tailight. Plan is to remove the module and put a stock tailight on and check some more.
the bike is an 08 Ultra. Like I mentioned, it has a run/brake module and the BAL tailight. I plugged in the tourpak lights and have nothing there either. I guess I will have to check the shop manual for wiring diagrams, unless someone has one they can upload???
Did you lower the rear of the bike?
Are you heavy and riding 2-up with luggage?
Tail light wire loom runs under the fender.
Very easy for tire to rub against wires.
I was doing a quick check before leaving work the other morning and noticed my brake lights and running lights were out. Pretty scary because I have to do a 5 mile stretch on I-95 at 6AM with a bunch of half asleep people rushing to work. I checked and the hazards worked so I turned them on.
I haven't had much time to check it yet but I did pull the seat and look around. I see no bad wires. Everything is plugged in. I have power to the orange wire at the plug that goes under the fender. When I put the turn signal on to check for power the brake light and both turns signals flash. Thats as far as I got.
I have a brake/run module in the mix, and a BAL tailight. Plan is to remove the module and put a stock tailight on and check some more.
the bike is an 08 Ultra. Like I mentioned, it has a run/brake module and the BAL tailight. I plugged in the tourpak lights and have nothing there either. I guess I will have to check the shop manual for wiring diagrams, unless someone has one they can upload???
This is not correct operation. If I am understanding correctly what you wrote.
If you engaged a turn signal and both turn signals plus the brake light flashes, that is not correct.
7 Surprising Harley-Davidson Products that Are Not Motorcycles
Slideshow: The bar-and-shield logo shows up on far more than motorcycles, some of the company's most unexpected products have nothing to do with riding.
Slideshow: From the troubled AMF years to modern misfires, these bikes earned reputations for reliability issues, questionable engineering, or disappointing performance.
Crazy Bunderbike Build Looks Amazing, But Is It Impossible to Ride?
Slideshow: The Swiss custom shop has taken a Harley Softail and stretched it into something so long and low that it looks closer to a rolling sculpture than a conventional motorcycle.
Engraved Rebellion: Inside Bundnerbike's Glam Rock II
Slideshow: A standard cruiser becomes an intricate metal canvas in the hands of a Swiss custom house known for pushing Harley-Davidson platforms far beyond their factory brief.
Slideshow: Harley-Davidson's challenges aren't abstract; they show up in dropping shipments, shrinking dealer traffic, and strategic decisions that aren't yet translating into growth.