Drag Specialties Steering Stem Bearing Dust Seal Location?
Drag Specialties Steering Stem Bearing Dust Seal Location?
Hey guys
Im replacing the steering stem bearings on my 15 FXDF and decided to use the drag specialties kit. I noticed it comes with dust seals but no instructions on placement of them with the factory washer etc.
do I pack the bearing, pop the seal on then put the factory washer over top of that?
Im replacing the steering stem bearings on my 15 FXDF and decided to use the drag specialties kit. I noticed it comes with dust seals but no instructions on placement of them with the factory washer etc.
do I pack the bearing, pop the seal on then put the factory washer over top of that?
Club Member
Joined: Oct 2011
Posts: 11,175
Likes: 2,483
From: Nor Cal
Here's my interpretation...
You bought an aftermarket Bearing Kit that covers many applications.
Your FXDF was supplied without seals, but instead used "Dirt Guards".
Why don't you install the bearings like it came the MoCo and disregard those included Seals.
Unless you have a very good reason not to.
You bought an aftermarket Bearing Kit that covers many applications.
Your FXDF was supplied without seals, but instead used "Dirt Guards".
Why don't you install the bearings like it came the MoCo and disregard those included Seals.
Unless you have a very good reason not to.
Thread
Thread Starter
Forum
Replies
Last Post
