Going nowhere fast!
#11
Have the same bike, same year...just had something similar going on. I swapped out my bars with apes and bike ran fine. After all the work was done I loosened my controls and bars to adjust everything and then after I tightened it all up I was having this same issue. Found that it was blowing the ignition fuse. Took apart the throttle side controls and sure enough...one of the wires got crushed when I was readjusting everything. It was stripped and grounding out on the bars. Wrapped the bare area with electrical tape and everything is fine now but you said you checked all of your fuses already so probably not the same issue.
#12
#13
Thread
Thread Starter
Forum
Replies
Last Post
ghost183
Screamin Eagle CVO Models
11
05-28-2018 10:49 AM