92 fatboy floorboard to peg conversion - HELP
Thread Starter
|
Stage II
Joined: Dec 2017
Posts: 2
Likes: 0
From: Vancouver BC
92 fatboy floorboard to peg conversion - HELP
Hello guys
long time reader first time poster... I have a 92 fatboy
I recently bought some 3 inch peg forward controls to make my bike easier to ride for my old man (complains about harsh seated angle for hips) so he can stretch out better. The ebay vendor assured it would fit on a fatboy, so I bought as the price was good. I put them on today and of course I barely have enough clearance on the right side, and Im not sure how I stick the little end piece with the wires into the new floor peg brake unit (see pics below)
I wanted to see if anyone has done this, maybe they could point me in the right direction. Thanks in advance for reading
Pic one: the old bits on the old brake (is that little tank a resevior) assembly.
Pic two: clearance on the newly installed brake assembly. what goes into that little hole on the end?
pic 3: another pic
long time reader first time poster... I have a 92 fatboy
I recently bought some 3 inch peg forward controls to make my bike easier to ride for my old man (complains about harsh seated angle for hips) so he can stretch out better. The ebay vendor assured it would fit on a fatboy, so I bought as the price was good. I put them on today and of course I barely have enough clearance on the right side, and Im not sure how I stick the little end piece with the wires into the new floor peg brake unit (see pics below)
I wanted to see if anyone has done this, maybe they could point me in the right direction. Thanks in advance for reading
Pic one: the old bits on the old brake (is that little tank a resevior) assembly.
Pic two: clearance on the newly installed brake assembly. what goes into that little hole on the end?
pic 3: another pic
Last edited by billyzahn; Dec 17, 2017 at 10:50 PM.
Thread
Thread Starter
Forum
Replies
Last Post
