FP3 with Cams
Road Master
Joined: Nov 2016
Posts: 1,158
Likes: 788
From: Louisiana
I have had great success with my 2008 Softail with cams and the FP3. I Installed the Cycle Rama 570-2 cams.
The cams werent listed in the FP3 so I called V&H support. They were able to customize the map for my bike and it runs great.
After a few weeks I called again to ask them to look over my map and see if they could fine tune it even further and they did. That was almost 2 years ago.
I would highly recommend the FP3 with cams.
OTOH if you decide down the road to go stage 3 or 4 you will be better off going with a power vision and a dyno tune.
The cams werent listed in the FP3 so I called V&H support. They were able to customize the map for my bike and it runs great.
After a few weeks I called again to ask them to look over my map and see if they could fine tune it even further and they did. That was almost 2 years ago.
I would highly recommend the FP3 with cams.
OTOH if you decide down the road to go stage 3 or 4 you will be better off going with a power vision and a dyno tune.
Banned
Joined: Sep 2019
Posts: 241
Likes: 137
From: Los Angeles
Or find yourself a Fuelpak Pro tuner and get your current FP3 dyno-tuned, saving you valuable $$$.
Road Master
Joined: Nov 2016
Posts: 1,158
Likes: 788
From: Louisiana
Thats good to know. My bike is fine where its at and I dont foresee going past stage 2.
Banned
Joined: Sep 2019
Posts: 241
Likes: 137
From: Los Angeles
Cruiser
Joined: Nov 2012
Posts: 165
Likes: 20
From: Fort Bragg, NC
That was yesterday, we're good to go for any server changes today. Hit me up at FPPro@VanceandHines.com and I'll get you hooked up instead of having to go through the normal channels.
Thread
Thread Starter
Forum
Replies
Last Post
