Deuce bars question - Wild1 Lo-Pro pullback drags
Thread Starter
|
Stellar HDF Member
Joined: Nov 2005
Posts: 2,272
Likes: 10
From: Orange VA
Deuce bars question - Wild1 Lo-Pro pullback drags
Wife is putting Wild 1 Low Profile Pullback drags on her bike. W0560, 4" rise, 30.5" wide and 14.5" pullback.
Want to know if anyone else put them on and if they went with different length cables? Did you need to extend the control wiring?
I know, I know.... mock them up and check to see what you need. But I have chrome controls and switches in hand, and the bars are on order. I want to order the chrome cables and lines today or tomorow so I can have all the parts together to do the install by the end of the week.
Appreciate the help.
JB
Want to know if anyone else put them on and if they went with different length cables? Did you need to extend the control wiring?
I know, I know.... mock them up and check to see what you need. But I have chrome controls and switches in hand, and the bars are on order. I want to order the chrome cables and lines today or tomorow so I can have all the parts together to do the install by the end of the week.
Appreciate the help.
JB
3rd Gear
Joined: Feb 2008
Posts: 7
Likes: 0
RE: Deuce bars question - Wild1 Lo-Pro pullback drags
I don't think that you have to extend the cables for that bike and bars, but if you had to, then talk to the guys at hdbikeparts.com. They have always gave me good advise and the can tell you if you need to by cables or not.
Thread
Thread Starter
Forum
Replies
Last Post
