Attn: all Crossbones Owners and future owners!!!!
Road Master
Joined: May 2008
Posts: 1,231
Likes: 2
From: Upstate NY
RE: Attn: all Crossbones Owners and future owners!!!!
What setting for the Fuelpak did you use. I've been told to use FP-0604. Is that what setting you used? Thanks for the install info, it makes life a lot earier.
Tourer
Joined: Mar 2008
Posts: 323
Likes: 0
From: Philadelphia, PA
RE: Attn: all Crossbones Owners and future owners!!!!
I just installed the fuel pack on my dads XBONES and had no problems getting it in. I'll take pics and post them. Figured I'd try it on his bike before I did mine 
Road Warrior
Joined: May 2008
Posts: 1,606
Likes: 29
From: Baytown Tx.
RE: Attn: all Crossbones Owners and future owners!!!!
ORIGINAL: ken thompson
Finally saw a Crossbones at the dealer today. Beautiful bike. The dealer had already swapped out the seat bcause no one there could touch the ground with the original one. They said you had to be like 6'4" for the original seat to be any good.
Finally saw a Crossbones at the dealer today. Beautiful bike. The dealer had already swapped out the seat bcause no one there could touch the ground with the original one. They said you had to be like 6'4" for the original seat to be any good.
Road Master
Joined: May 2008
Posts: 1,231
Likes: 2
From: Upstate NY
RE: Attn: all Crossbones Owners and future owners!!!!
Mannnn, I would appreciate that, a picture is worth a 1,000 words. Somebody said that before, but it's true.
What settings did you use for your dads fuelpak? FP-0604 I hope, because that's the one I was told to use. Don't know if it's right or not.
Thanks
What settings did you use for your dads fuelpak? FP-0604 I hope, because that's the one I was told to use. Don't know if it's right or not.
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
White Guy
Exhaust System Topics
5
Feb 28, 2008 02:39 PM
