Springer Handlebars - new owner
Thread Starter
|
Stage I
Joined: Feb 2011
Posts: 1
Likes: 0
Springer Handlebars - new owner
Hey,
Just bought a 2005 Springer Classic and I've got the itch to change it up a bit. Already purchased progressive's for the back, low down plate holder, new derby cover and removed the passenger seat and rack. I'd like to put on a set of either Hollywood or Speedster bars... Paughco makes them in two models. One for risers and another that says it only fits their front ends. Is there a way to get them to fit without risers?
Also, would like to dump the front lights, but was told I need to solder in some kind of resister to close the loop? Anyone done this?
Just bought a 2005 Springer Classic and I've got the itch to change it up a bit. Already purchased progressive's for the back, low down plate holder, new derby cover and removed the passenger seat and rack. I'd like to put on a set of either Hollywood or Speedster bars... Paughco makes them in two models. One for risers and another that says it only fits their front ends. Is there a way to get them to fit without risers?
Also, would like to dump the front lights, but was told I need to solder in some kind of resister to close the loop? Anyone done this?
Elite HDF Member
Joined: Jul 2007
Posts: 3,891
Likes: 54
From: Mansfield, MA
Check member fallenspringer.. I believe he's running with out a front fender.
To get the hollywood bars to work, I think you'll need an adapter plate for the risers to use standard FL bars
To get the hollywood bars to work, I think you'll need an adapter plate for the risers to use standard FL bars
Last edited by hspring03; Feb 15, 2011 at 07:07 PM.
Thread
Thread Starter
Forum
Replies
Last Post
