Handlebar swap help
Thread Starter
|
Intermediate
Joined: May 2010
Posts: 25
Likes: 0
Handlebar swap help
do i have to cut and splice electrical from under the seat to get a narrow end for feeding through new handlebars? or is there a trick to the disconnect that allows grip end components to feed through the bars? yea, i did a search, but came up empty with "handlebar electrical disconnect".
Stellar HDF Member
Joined: Nov 2004
Posts: 3,156
Likes: 41
From: So Cal
Disconnect under the gas tank at the block or easier since you usually need to lenghten the wiring to go through the bars is just cut them just under the gas tank feed through the bars add extentions as needed and solder and shrink wrap, youll never know the splice is there.
Use a vacumn cleaner and a cotton ball tied to a string to feed through the bars and then tie to the wiring and pull
Use a vacumn cleaner and a cotton ball tied to a string to feed through the bars and then tie to the wiring and pull
Last edited by XARAN; Jun 16, 2011 at 02:21 PM.
Thread
Thread Starter
Forum
Replies
Last Post
DrPlastic
Sportster Models
4
Nov 10, 2007 10:22 PM
